11
6
7
6. Hold the Console (16) near the Upright (13). Connect
the console wire to the Upper Wire (36). Next, connect
the ground wire to the Upright with the Ground Screw
(27).
Insert the excess console wire and Upper Wire (36)
down into the Upright (13). Next, move the Console
(16) toward the Upright, at the same time inserting the
excess ground wire up into the hole in the underside
of the Console. Continue until all of the excess ground
wire is inside of the Console. Attach the Console to
the Upright with four M5 x 12mm Screws (49).
Be
careful to avoid pinching the wires.
16
6
Be careful to
avoid pinching
the wires.
13
49
36
27
Ground
Wire
Console
Wire
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent.
Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, first
see step 6 on page 6 and remove the console from
the upright. Next, see step 5 and insert three batteries
into the console. Reattach the console to the upright,
being careful not to pinch the wires.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left side shield must be removed.
Turn the Crank (21) to the position shown. Using an
adjustable spanner, turn the Left Pedal (24) clockwise
and remove it. Next, remove the five M4 x 25mm
Screws (52) and the M4 x 19mm Screw (42) from the
Left Side Shield (17). Carefully remove the Left Side
Shield.
Next, locate the Reed Switch (43). Turn the Crank
(21) until the Magnet (38) is aligned with the Reed
Switch. Loosen, but do not remove, the M4 x 12mm
Screw (46). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screw.
Turn the Crank for a moment. Repeat until the con-
sole displays correct feedback. When the Reed
Switch is correctly adjusted, reattach the left side
shield and the left pedal.
PULSE SENSOR TROUBLESHOOTING
See step 3 on page 10.
MAINTENANCE AND TROUBLESHOOTING
52
42
17
21
38
43
46
52
24
21
5
5. The Console (16) requires three 1.5V AA batteries;
alkaline batteries are recommended. Insert three bat-
teries into the Console.
Make sure that the batteries
are oriented as shown by the markings inside the
Console.
16
Batteries
7. Attach the Seat (12) to the Seat Post (5) with three M8
Flat Washers (51) and three M8 Nylon Locknuts (10).
Note: The Flat Washers and Nylon Locknuts may be
preattached to the underside of the Seat.
51
12
51
10
10
5
