9
10.
Make sure that all parts of the elliptical exerciser are properly tightened.
Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
9
12
16
99
14
9. Attach a Pedal Bracket (16) to the Left Pedal
Arm (14) with two M8 x 65mm Button Screws
(99), two M8 Large Washers (53), and two M8
Locknuts (46).
Identify the Left Pedal (13), which is marked
with a “Left” sticker.
Attach the Left Pedal (13) to the Left Pedal Arm
(14) with two M8 x 50mm Button Screws (89),
two M8 Split Washers (100), and two M8 Large
Washers (53).
Attach the other Pedal Bracket (not shown)
and the Right Pedal (12) to the Right Pedal
Arm (103) in the same way.
103
53
53
53
89
100
13
46
8. Apply a small amount of grease to the barrel of
an M10 x 52mm Bolt Set (27) and to the sur-
faces of the two Leg Bushings (28) in the left
Handlebar Leg (79).
Attach the left Handlebar Leg (79) to the Left
Pedal Arm (14) with the M10 x 52mm Bolt Set
(27).
Do not overtighten the Bolt Set; the left
Handlebar Leg must pivot freely.
Attach the right Handlebar Leg (79) to the
Right Pedal Arm (103) in the same way.
See step 3.
Tighten the M10 x 88mm Button
Screws (63).
See step 6.
Tighten the M8 x 45mm Button
Bolts (50).
14
103
27
27
28
28
Grease
Grease
8
79
79
