7
5. Apply a small amount of grease to a Wave
Washer (27) and slide it onto one end of the Pivot
Axle (16). Next, slide an M8 Washer (64) and a
Pivot Cover (14) onto an M8 x 23mm Shoulder
Screw (65), and tighten the Button Screw into the
Pivot Axle.
Apply a generous amount of grease to the Pivot
Axle (16). Identify the Left and Right Upper Body
Legs (6, 7), which are marked with “L” and “R”
stickers. While another person aligns the Left and
Right Upper Body Legs with the Upright (2) as
shown, insert the Pivot Axle into the Upper Body
Legs and the Upright.
Be careful not to damage
the Upper Wire Harness (18) with the Pivot
Axle.
Apply a generous amount of grease to a Wave
Washer (27), and place it on the end of the Pivot
Axle (16). Next, slide an M8 Washer (64) and a
Pivot Cover (14) onto an M8 x 23mm Shoulder
Screw (65), and tighten the Button Screw into the
Pivot Axle.
Make sure that the Wave Washer
remains on the end of the Pivot Axle.
5
6. Apply a generous amount of grease to the axle on
the Upper Body Leg (6). Then, apply grease to a
Large Wave Washer (20) and slide it onto the axle.
Apply a generous amount of grease to the Left
Crank Arm (42). Then, slide an Inner Crank Arm
Bushing (26) onto the Left Crank Arm.
Make sure
the flat side of the Inner Crank Arm Bushing is
facing away from the Left Crank Arm.
Slide the Left Pedal Arm (21) onto the Left Upper
Body Leg (6) and the Left Crank Arm (42).
Repeat this step for the other side of the ellipti-
cal exerciser.
6
14
27
7
2
18
6
65
64
14
64
27
16
Grease
Grease
65
6
21
20
Grease
Grease
42
26
4
4. Identify the Left Pedal Arm (21), which is marked
with a “Left” sticker. Attach a Pedal (19) to the
Left Pedal Arm with three M4 x 19mm Screws
(68) and three Star Washers (85).
Attach the other Pedal (not shown) to the Right
Pedal Arm (not shown) in the same way.
19
21
68
85
85
Hexagonal
Holes
