8
3. Slide the two Wheel Housings (45) onto the
Base (52). Attach each Wheel Housing with two
M6 x 58mm Bolts (13), two M6 Flat Washers
(32), and two M6 Nuts (43).
3
52
13
32
32
45
43
13
32
32
45
43
4. Remove the bolts and the cardboard packaging
from both sides of the Hood (65). The bolts can
be discarded.
Position the Base (52) as close to the front of
the treadmill as possible.
See the inset drawing.
Locate the wire tie in
the Right Upright (54). Tie the wire tie securely
to the connector on the end of the Wire Harness
(39). Next, pull the opposite end of the wire tie
out of the upper end of the Right Upright, until
the Wire Harness is routed completely through
the Right Upright. Secure the Wire Harness to
the upper end of the Right Upright so that it will
not fall inside.
52
4
39
54
65
54
39
Wire Tie
