7
4. Hold a Frame Spacer (27) against the right side of the
Frame (79) as shown. Insert a Frame Bolt (70) into the
frame bolt hole in the Upright Spacer and the Frame.
Next, tighten a Spacer Screw (45) into the Upright
Spacer and the Frame. Then, remove the Frame Bolt.
Repeat this step on the other side of the Frame.
4
70
45
79
27
5. Position the Base (46) over the Frame (79) as shown.
Insert the Wire Harness (60) into the large hole in the
Right Upright (62) and out of the top.
62
60
79
46
6. Raise the Right Upright (62) and the Left Upright (not
shown) so the Base (46) is flat on the floor.
Make sure
that the upper end of the Wire Harness (not shown)
does not fall into the Right Upright.
With the help of a second person, lift and hold the Frame
(79) between the Right Upright (62) and the Left Upright
(not shown). Finger tighten a Frame Bolt (70) with a
Washer (66) and a 3/8” Star Washer (29) through the
Right Upright and the Frame Spacer (27) and into the
Frame.
Do not tighten the Frame Bolt yet.
Repeat this
step on the left side of the treadmill.
46
29
62
79
27
66
70
3. Have a second person hold the Base (46) in a vertical
position as shown. Hold the Right Upright (62) against
the Base so the indicated large hole is in the position
shown. Attach the Right Upright with two Upright Bolts
(65), two 3/8” Washers (66), and two 3/8” Nuts (61) as
shown.
Do not tighten the Upright Bolts yet.
Attach the Left Upright (not shown) to the Base (46) in
the same way. Note: The Left Upright does not have a
large hole.
61
66
65
65
62
46
Large
Hole
Large
Hole
3
5
6
66
