6
3. Hold the Console Base (87) near the right Handrail (4).
Make a loop with the indicated plastic tie and insert the
two Wires (53) through the loop. Pull out only enough
Wire to connect the Wires to the two connectors in the
Console Base (87). Important: Make sure that the
Wires are fully inserted. WARNING: Do not discon-
nect or connect the Wires while the treadmill power
cord is plugged in.
Refer drawing 3a. Set the Console Base (87) on the
Handrails (4). Thread four Console Screws (3) into the
Handrails and the Console Base. After all four Screws
have been started, tighten the Screws until they are
snug; do not overtighten the Screws.
Feed the excess Wire Harness (53) into the upper end
of the right Handrail (4). Pull the plastic tie tight and cut
off the end.
4. Attach the Storage Latch (16) to the left Upright (38)
with two Latch Screws (14). Note: If there are four holes
in the left Upright, use the two indicated holes. Be care-
ful not to overtighten the Screws.
Refer to step 2. Tighten the four Handrail Bolts (1).
5. Loosely thread the bottom two Rack Screws (14) into the
Upright (38) first. Then, loosely thread the other four
Screws and then go back and tighten all of the Screws.
Set a 3-lb. Weight (not shown) on the bottom hanger on
the Weight Rack (15), a 2-lb. Weight on the middle
hanger, and a 1-lb. Weight on the top hanger.
Attach the other Weight Rack and Weights (not shown)
to the left Upright in the same way.
6. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill.
14
38
16
Holes
38
15
14
14
Hanger
14
5
4
3
3
4
53
87
3
3a
4
Plastic
Tie
Plastic
Tie
87
53
4
