6
3
5
3. Attach the Seat (32) to the Seat Post (33) with the
three M8 Nylon Locknuts (15) and the three M8 Flat
Washers (43). Note: The Nylon Locknuts and the
Flat Washers may be preattached to the Seat.
Make sure that the Frame Bushing (35) is pressed
into the Frame (1).
Insert the Seat Post (33) into the Frame (1). Align
one of the holes in the Seat Post with the welded
nut on the Frame, and then tighten the Seat Knob
(36) into the welded nut and the Seat Post.
Make
sure that the shaft of the Seat Knob is inserted
into one of the holes in the Seat Post; do not
insert the Seat Knob under the Seat Post.
4. Route the Extension Wire (16) up through the
Console Mount (30) as shown, and insert the
Console Mount into the Upright (19).
Be careful to
avoid pinching the Extension Wire.
Attach the
Console Mount with the M4 x 15mm Screw (4).
Attach the Handlebar (24) to the bracket on the
Upright (19) with two 5/16” x 35mm Carriage Bolts
(23) and two 5/16” Nylon Locknuts (9).
5. The Console (26) requires one 1.5V AAA battery. An
alkaline battery is recommended. Locate the battery
door on the back of the Console. Press the tab on
the battery door, and remove the battery door. Insert
a battery into the battery holder inside of the
Console;
make sure that the negative end of the
battery (marked “—”) is touching the spring in
the battery holder.
Reattach the battery door.
Connect the Extension Wire (16) to the Console
(26). Insert the wires down into the Console Mount
(30). Slide the Console onto the tab on the Console
Mount.
32
33
1
35
36
43
43
15
15
26
16
30
Tab
6
6. Identify the Right Pedal (39), which is marked with
an “R.” Using an adjustable spanner, tighten the
Right Pedal
clockwise
into the right arm of the Crank
(12). Next, tighten the Left Pedal (not shown)
coun-
terclockwise
into the left arm of the Crank.
Fully
tighten both Pedals.
7.
Make sure that all parts are properly tightened
before you use the exercise cycle.
39
12
4
16
24
23
30
19
4
9
9
Welded Nut
Battery
Door
