Wesco WS2933, Manual

Page: 21 / 32

21
EN
on the work piece, continue to saw along the cutting line.
4. METAL CUTTING
Use a finer tooth blade for ferrous metals and a coarse
tooth blade for non-ferrous metals.
When cutting thin sheet metals, always clamp wood on
both sides of the sheet to reduce vibration or tearing of
the sheet metal. Both wood and sheet metal must be cut.
Do not force the cutting blade when cutting thin metal
or sheet steel, as they are harder materials and will take
longer to cut. Excessive blade force may reduce the life
of the blade or damage the motor. To reduce heat during
metal cutting, add a little lubricant along the cutting line.
MAINTENANCE
Before any work on the machine itself,
remove the battery pack.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of
tool and battery is 0
℃ -45 ℃ .
The recommended ambient temperature range for the
charging system during charging is 0
℃ -40 ℃ .
TROUBLESHOOTING
Symptom Possible
Causes Possible
Solution
The Tool
Suddenly
Stops During
Operation. Over load
Battery
temperature
too high
Low battery
capacity
Relieve the
load on the
machine
immediately
and allow
cooling for
approx. 30
seconds by
running the
machine on
no-load.
Charge the
battery pack.