Page
4
of
14
© Copyright 2016 WESCO Industrial Products, Inc. Specifications subject to change. Not responsible for errors or omissions.
2. ATTACHING DRAW-BAR TO PUMP UNIT (continued)
2.2
Set the Control Handle (117S) to the ‘
LOWER
’ position, then pass the Adjusting Nut
(104S), Adjusting Bolt (103S) and Chain (102S) through the hole of the axle (105S) by
hand (See Fig. 3).
Fig. 3
2.3
Press the Draw-Bar (110S) down and then take away the Pin (See Item 2 in Fig. 1).
2.4
Set the Control Handle (117S) to the ‘
RAISE
’ position, then raise the Lever Plate
(319S) with the Pin (Item 2 in Fig. 1) and insert the Adjusting Bolt (103S) into the front
slot of t h e Lever Plate (319S).
Note: Keep the Adjusting Nut (104S) on the underside of the lever plate.
2.5
Use a hammer to insert another Elastic Pin (106S) into the Axle with Hole (105S). The
Draw-Bar is now assembled to the pump.
3. ADJUSTING RELEASE DEVICE
The Control Handle (117S) is located on the Draw-Bar of the truck and can be adjusted
to three different positions:
Raise
-handle down
Drive
-handle in center position
Lower
-handle up, the lever moves back to the drive position when released.
If however they have been changed, you can adjust according to following step:
3.1
If the forks elevate while pumping in the
DRIVE
position, turn the Adjusting Nut
(104S) on the Adjusting Bolt (103S) or Screw (318S) clockwise until pumping action
does not raise the forks and the
DRIVE
position functions properly.
Stainless Steel Pallet Truck
(Part # 272152)
Instruction Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR WESCO PALLET
TRUCK, READ THESE INSTRUCTIONS ENTIRELY BEFORE USING.
Industrial Products, Inc.
