WERTHEIM 6030, Instruction Manual

Page: 11 / 12

9
Your new Wertheim cleaner, which
has been fully tested, inspected and
adjusted, carries in the case of
domestic users, a 2 year repair or
replacement
Guarantee against
manufacturing defects. In the case of
commercial users the period is 90
days. Brushes, Belts and Filters,
unless
actually defective in
manufacture are not subject to this
guarantee since their length of life
depends upon usage and care given.
Any transportation costs involved in
the repair of the appliance or the
replacement of a defective part shall
be borne by the claimant. This
guarantee commences from the date
of purchase of the cleaner.
When properly used and cared for,
your new cleaner will render excellent
service, and therefore, the purchaser
should carefully read the Instruction
book, as misuse or failure to follow the
instructions makes the Guarantee
void. It also becomes void if the
product is used on an electric voltage
other than that shown on the Rating
Plate. E.H.A. Pty. Ltd is unable to
accept responsibility under this
guarantee for damage from repair
work carried out by other than
authorised Service Retailers or
Centres, or from the use of other than
genuine parts.
This guarantee does not apply to the
cost of replacing any part of the
product due to normal wear and tear,
alteration,
improper installation,
physical abuse, misuse or accident.
In the event of service or advice being
needed, please see details below for
address.
The benefits conferred by this
Guarantee are in addition to all other
rights and remedies in respect of the
product which the consumer has
under the Trade Practices Act and
other State and Territory laws.
2 YEAR
GUARANTEE
This Guarantee applies in Australia and New Zealand only.
For the guarantee in another country, please contact
your local retailer / distributor.
Keep this Guarantee and your receipt as proof of purchase.
Purchase Date......../......../........
Our policy is one of continuous development and accordingly we reserve the right to
change specifications without prior knowledge.
E.H.A. Pty Ltd
(ACN 007 539 577)
Locked Bag 120 Silverwater D.C. 1811 NSW
3180 I/B 6/3/03 8:52 AM Page 10
11
FILTER MAINTENANCE: The HEPA filter should be washed or
replaced whenever the filter indicator comes on with a red light or
every fifth dust bag. Do not use cleaner without filters fitted.
1. To remove Motor Filter , open
cleaner cover and lift bag holder.
2. Remove Motor Filter by holding
tab and pull out from holder.
4. To gain access to HEPA Filter and
Micro Filters , press rear cover
release latch and remove cover.
3. Before replacing Motor Filter ,
remove any dust and refit new filter
securely in place.
5. Remove HEPA Filter , shake off any
dust and wash the dirty side under
warm tap water. Dry thoroughly.
6. Replace the 2 Micro Filters and
refit under filter cover, refit HEPA
Filter and close back securely.
Motor Filter
10
2193412-05.indd 11 1/2/08 11:10:06 AM