Page 7
MODEL A510022
STRAIGHT LOOP INSERT
See A510021 Straight Loop Insert Manual for anchorage casting instructions.
Internal Tooth
Lock Washer
WARNING: Do not install if insert was knocked over during
installation. Mega Swivel must mount flush to surface when fastened
with the proper torque.
Torque Range:
70 to 80 ft-lbs
(10-11 kgfm)
Orange
Housing
Plastic Bolt to
be removed
5/8-11x3.25 inch
Hex Cap Bolt *
Note: Ensure internal threads are
thoroughly coated with NLGI2
multi-purpose lithium grease
(meeting Sinopec specification
Q/SH303 242-2007 or equivalent).
1. Strip decking to expose the Straight Loop Insert.
2. Ensure that anchorage was properly installed. Orange indicator should be flush with
concrete surface, and at least 9 inches (23 cm) from any edge or corner. Concrete
should be at least 8 inches (20 cm) thick and cured to a minimum of 3000 psi (20.7 MPa).
3. Remove plastic bolt and o-ring using 1/2 inch allen wrench.
4. Save plastic bolt and o-ring to re-insert into Straight Loop Insert when not in use.
5. Insert bolt and washer through Mega Swivel and into the threaded
hole of the Straight Loop Insert.
6. To fasten Mega Swivel, tighten bolt* to 70-80 ft-lbs (10-11 kgfm) using torque wrench.
Summary of Contents for A320003
Page 11: ...NOTES ...
