W
E
N
S
H
IN
G C
O
N
F
ID
E
N
T
IA
L
D
O N
O
T D
IS
T
R
IB
U
T
IO
N
W
E
N
S
H
IN
G C
O
N
F
ID
E
N
T
IA
L
D
O N
O
T D
IS
T
R
IB
U
T
IO
N
IR
Link P
WS-AV2-Sender RX
IR
Link P
ANT
WS-AV2-Sender TX
7
8
ANT
Press the pairing key for 5 seconds from Transmitter and Receiver until the LED
blinks in blue.In the pairing mode, if it were not pairing successfully in 30
seconds, the system exits this mode automatically.If pairing is done successfully,
both LED blinks steady from both Transmitter and Receiver suggesting they are
connecting, the Receiver shows video output from the screen.(P7)
Pairing Methods
P7
Transmitting and receiver
ends Long press for about 5
seconds while”Pairing" button
Blue light blinking when pairing
Steady blue light indicates
successful pairing And outputs
the image
Remote Controller
This AV transceiver supports IR transferring; it works well when the remote
controller focuses on the IR receptor to control other devices remotely.(P8)
▶
IR remote control
IR
Link P
WS-AV2-Sender RX
IR
ANT
P8
Accessories
Adapter*2 Signal conversion line*2 Antenna*2(P9)
▶
▶
P9
AV2-RS485 Operation Guide
Installation
▶
Transmitter
1.Connect yellow terminal from signal cable to video port.Link signal cable to
3.5mm terminal from female connector at Transmitter.(P10)
(Yellow - Yellow)
P10
2.Put antenna into the antenna terminal at Transmitter.(P11)
Link P
ANT
WS-AV2-Sender TX
P11
Rs485 Power
Rs485 Power
3.Positioned the dip switch to the desired group.(P12)
Both the transmitter and receiver
to the same number allocated
P12
Link P
ANT
4.Connect the attached adapter to the corresponding position from the green
terminal bracket to make sure it’s being tightly screwed by using flat-blade
screwdriver.Have D+ and D- from RS-485 tightly screwed to the corresponding
position from the green terminal bracket as shown from figure below by using
flat-blade screwdriver (only if it’s necessary).Link the green terminal bracket
to female connector from Transmitter, the LED blinks steady in yellow and the
same time another LED blinks in blue for 1 second and goes off showing the
device is functioning well.(P13)
WS-AV2-Sender TX
Blue lights 1 second, yellow lit
P13
Receiver
▶
Rs485 Power
1.Connect yellow terminal from signal cable to video port.Link signal cable to
3.5mm terminal from female connector at Receiver.(P14)
(Yellow - Yellow)
P14
