Wenglor ZAI02PN0 Series, Operationg Instructions

Page: 18 / 29

18
EN
7.7.3 Diagnostic alarms
The appropriate alarm module should be set up in the controller in the case of an alarm message originating
from the connection box by short circuit at the ports (hardware interrupt OBs OB40-OB47). If this is not the
case, the CPU goes into the STOP mode in the case of an interrupt triggering event. The following alarm mes-
sages are output from the connection box to the controller:
Diagnostic I/O: Short-circuit after V
CC
(coming)
Api 0x00000000
Slot 0x0001
Subslot 0x0001
Channel 0: Port 0 (Pin2 or Pin4)
1: Port 1 (Pin2 or Pin4)
2: Port 2 (Pin2 or Pin4)
3: Port 3 (Pin2 or Pin4)
4: Port 4 (Pin2 or Pin4)
5: Port 5 (Pin2 or Pin4)
6: Port 6 (Pin2 or Pin4)
7: Port 7 (Pin2 or Pin4)
AlarmSpecifier 0x01, Diagnosis appears
ChannelErrorType 0x0100 (manufacturer-specific)
Diagnostic I/O: Short-circuit after V
CC
(going)
Api 0x00000000
Slot 0x0001
Subslot 0x0001
Channel 0: Port 0 (Pin2 or Pin4)
1: Port 1 (Pin2 or Pin4)
2: Port 2 (Pin2 or Pin4)
3: Port 3 (Pin2 or Pin4)
4: Port 4 (Pin2 or Pin4)
5: Port 5 (Pin2 or Pin4)
6: Port 6 (Pin2 or Pin4)
7: Port 7 (Pin2 or Pin4)
AlarmSpecifier 0x02, Diagnosis disappears
ChannelErrorType 0x0100 (manufacturer-specific)