16
Installation and Electrical Connection
Tilting the sensor away from the conveyor plane results in an area with reduced detection of small objects
which are far away from the sensor, i.e. close to the reflector.
NOTE!
Ideal alignment can be easily determined by means of the band of light above the conveyor
belt. First of all, height is determined from the conveyor belt to the uppermost point of the
band of light directly on the sensor. Afterwards, height is determined from the conveyor belt
to the uppermost point of the band of light on the reflector. Alignment is ideal when these
two distances are identical.
wenglor recommends a sensor adjustment range with parallel upper light-band edge, or
maximum downward sloping of the upper edge of the light band amounting to 2 mm within
the corresponding working range.
ATTENTION!
Risk of property damage in case of improper installation!
The product may be damaged.
• Installation instructions must be complied with.
CAUTION!
Risk of personal injury or property damage during installation!
Personal injury and damage to the product may occur.
• A safe installation environment must be assured.
