3
ASSEMBLE SLIDE LEG TO SIDE RAIL LEG
SIDE RAIL ASSEMBLY
Note:
The position of the (10) Slide Leg depends upon the Tourmaster Riser model. One of three
clearance holes in each Slide Leg is used to fasten the Slide Leg to the (8) Side Rail Leg
with a single (7) Capscrew, 5/16-18x1-3/4 inches long. The Tourmaster Riser model
determines which hole to use. To avoid alignment problems with the Riser, select the correct
application from the three methods shown in Step 1, below and on the following page.
1. Insert the (10) Slide Leg into the (8) Side Rail Leg and align the appropriate Clearance Hole of
the (10) Slide Leg to the clearance hole in the (8) Side Rail Leg as shown below and on the
next page.
Use the Right Hole for the following models:
•
For 3-step Tourmaster Risers with 24-inch deep steps
•
For 3-step Tourmaster Risers with 24-inch deep steps and the 4th step addition installed
1
(10) Slide Leg
Slide Leg
Right
Hole
(8) Side Rail Leg
Side Rail Leg Clearance Hole
(10) Slide Leg inserted into (8)
Side Rail Leg with the
right
hole
aligned to clearance hole in the
Side Rail Leg
