9
BEFORE OPERATING
Refer to the Audio System Owner’s Manual and the Audio System Mixer Users Guide for additional
information regarding set up and component connections.
1.
Make sure the Audio System Power Distribution Unit
ON-OFF
Switch is in the
OFF
Position.
2.
Connect a power cord from the Power Distribution Unit to a grounded 120 VAC power source. All
components are powered by this component.
3.
Connect the Amplifier
CHANNEL 1 OUTPUT
connector to a Loudspeaker
INPUT
connector and the
Amplifier
CHANNEL 2 OUTPUT
connector to the other Loudspeaker
INPUT
connector.
4.
Make sure that the CD/RW Recorder/Cassette Deck is connected as outlined in the previous
paragraphs.
5.
Make sure that the Mixer, Amplifier, and other component power switches are
OFF
and the level
controls are set to the lowest levels. Refer to the Audio System Owner’s Manual for additional
information.
6.
Place the speakers and microphones where they will be used during the performance. Avoid placing
microphones directly in front of speakers.
POWER UP THE AUDIO SYSTEM
1.
Power up the system as follows.
a.
Turn the Power Distribution Unit power switch
ON
.
b.
Power up the mixer, graphic equalizer, audio sources, and musical instruments. Refer to the
Audio System Owner’s Manual and other component manufacturer’s User Guides for operating
information.
b.
Press the CD/RW Recorder/Cassette Deck
POWER
push button.
c.
Power up the Amplifier.
d.
Apply a signal to the system and adjust the performance levels.
CASSETTE PLAYBACK
1.
Set the
REV MODE
switch (single-sided playback, both sides and stop, or both sides and continue).
2.
Load the cassette.
3.
Select
DOLBY NR ON
or
OFF
.
4.
Press the either
PLAY
push button.
5.
Adjust the level on the Mixer and Amplifier.
CASSETTE RECORDING
1.
Set the
REV MODE
switch (single-sided playback, both sides and stop, or both sides and continue).
2.
Load the cassette.
3.
Select the signal source:
a.
Press the
INPUT 2 SEL
push button to select
LINE INPUT 2
(record the signal from the Mixer) as
a recording source.
b.
Selecting
DISC
will record a signal from the CD/RW Recorder.
4.
Select
DOLBY NR ON
or
OFF
.
5.
Press the
RECORD
push button. This places the Deck into the Record Pause mode (display
indicators light).
6.
Introduce a signal to the Deck and adjust the recording level with the
INPUT
level control so that the
loudest sound causes the meters to reach about 0 dB.
7.
Press either the
PLAY
or
PAUSE
push button to start recording.
8.
Press the
STOP
push button to stop recording.
SETUP
