Wen RT6033, Instruction Manual, Page: 16 / 24

OPERATION
The included template guide is designed to fit the base of the router to
accurately duplicate curves and other shapes. You can also purchase the
template guide adapter (6033TGA) with a center hole diameter of 1-3/16"
from wenproducts.com, to fit other template guides and bushings.
1. Remove the four M5 X 10 screws holding the plastic base plate. Re-
move the base plate.
2. Place the template guide or template guide adapter in the recess on the
opposite side of the base plate and tighten with the M4 X 25 screws. En-
sure the template guide protrudes below the bottom of the base, allowing
the router to follow the template (Fig. 23).
3. Place the plastic base plate back onto the base of the router and tighten
all four screws (Fig. 23).
CUTTING ALONG A PROFILE
The profile guide helps to maintain an equal cutting distance along the
edge of an irregularly shaped workpiece.
1. Unscrew the four screws and remove the two sliding pads on the
straight guide fence bracket (Fig. 20).
2. Mount the profile guide in the center of the fence as shown (Fig. 21)
with the sliding wheel protruding outside and downwards. Tighten down
with the profile guide with screws.
3. Place router on workpiece at desired distance from edge to be copied.
4. Insert the fence poles into the holes on the router base and adjust until
the wheel is in contact with the workpiece. Tighten all the locking knobs.
CUTTING WITH A TEMPLATE
WHAT YOU NEED:
• Straight Guide Fence
• Profile Guide
WHAT YOU NEED:
• Template Guide
OR (SOLD SEPARATELY):
• Template Guide Adapter
• Generic Template Guide / Guide Bushing
Fig. 20
Fig. 21
Fig. 22
Fig. 23
16