6
PLANER SAFETY WARNINGS
PLANER SAFETY
1. Whenever adjusting or replacing any parts on
planer, turn switch OFF and remove plug from power
source.
2. Make sure all guards are properly attached and
securely fastened.
3. Make sure all moving parts are free from
interference.
4. Always wear eye protection or face shield.
5. Make sure blades are properly aligned and properly
attached to cutterhead.
6. Do not plug in planer unless the switch is in the off
position. After turning the switch on, allow the planer
to come to full speed before operating.
7. Keep hands clear of all moving parts.
8. Do not force cut. Slowing or stalling will overheat
motor. Allow automatic feed to function properly.
9. Use quality lumber. Blades last longer and cuts are
smoother with good quality wood.
10. Do not plane material shorter than 15”, narrower
than 3/4”, wider than 13”, or thinner than 1/2”.
11. Never make a cut deeper than 1/8”.
12. For workpieces longer than 24”, use material
support stands.
13. Always feed from infeed side to outfeed side,
and do not attempt to reverse direction of workpiece
being planed while it is being fed through the planer.
14. Take precautions against kickback. Do not permit
anyone to stand or cross in line of cutterhead’s
rotation. Kickback or thrown debris will travel in this
direction.
15. Turn switch off and disconnect power whenever
planer is not in use.
16. Replace cutting inserts if damaged. Rotate or
replace cutting inserts if dull.
17. Keep planer maintained. Follow maintenance
instructions.
18. Don’t plane against the grain of the wood. (Refer
to Operation Section, Page 14)
WARNING!
Do not let comfort or familiarity with the product replace strict adherence to product safety rules.
Failure to follow the safety instructions may result in serious personal injury.
These safety instructions can’t possibly warn of every scenario that may arise with this tool,
always make sure to stay alert and use common sense during operation.
