Wen MSA330, Instruction Manual

Page: 9 / 16

UNFOLDING THE LEGS
1. Place the miter saw stand on a flat surface with the
folded legs facing up.
2. Press down the release lever (Fig. 1 - 1) to disengage
the locking pin and rotate the leg up until the locking pin
clicks into the open position.
3. Deploy all four legs and lock them into place.
4. Flip the stand over to the upright position and check if
the stand is stable on the ground.
5. If adjustment is needed, turn the adjustment nut (Fig.
1 - 2) to set the height of the leg until the stand is stable.
INSTALLING THE WHEELS
1. Place wheel axle bar (Fig. 2 - 1) into wheel axle bar
slot (Fig. 2 - 2).
2. Install power block (Fig. 2 - 3) into power block slot
(Fig. 2 - 4).
3. Slide wheels onto the wheel axle assembly (Fig. 3 - 1).
Secure each wheel with a retaining ring (Fig. 3 - 2) that
goes in the groove around the wheel axle (Fig. 3 - 3). You
may need to use a rubber mallet to tap ring into place.
INSTALLING EXTENSION BAR, LOCK KNOBS, &
ROLLERS
1. With the extension arms inserted into the main frame,
install extension arm lock knobs (Fig. 4 - 1), two on each
end of the frame. Slide extension arms to a suitable dis-
tance to provide maximum support for your workpiece,
and lock the arms in position by tightening lock knobs.
2. Insert the rollers into the extension brackets and se-
cure each roller with a roller lock knob (Fig. 4 - 2).
3. The roller acts as both a roller support and a stop face
for your workpiece. To set up the rollers:
For Normal Cutting Operations
The top of the rollers should be level with the surface of
the miter saw’s table. This will ensure a level support for
your workpiece.
For Repetitive Cutting Operations
Turn the roller so the stop face side (Fig. 4 - 3) faces the
miter saw. Adjust the height of the roller so that the stop
face is level with the surface of the miter saw’s table.
Adjust the relevant extension arm until the stop face is at
the required stopping distance.
1
ASSEMBLY & ADJUSTMENTS
Fig. 1
Fig. 2
Fig. 3
Fig. 4
2
1
2
4
3
1
2
3
1
2
3
9