1
2
3
8
ASSEMBLY & ADJUSTMENTS
ATTACH THE SIDE TRAYS
1. Place the tool chest upside down, so that the seat cushion is
on the floor.
2. Align the outer holes on the side tray assembly (Fig. 1 - 1)
with the outer holes on the tool chest (Fig. 1 - 2).
3. Fasten the side tray assembly to the tool chest using an
M8x35 bolt, a washer, and a round-head nut. Repeat on all four
outer corners.
NOTE:
Your garage glider comes with eight M8 bolts; 4 of them
are 35mm long, and 4 are 40mm long. Be sure to use the short-
er (35mm) bolts for this step.
4. Tighten all four nuts with a 14mm wrench or socket (not
included).
ATTACH THE SUPPORT BARS
1. Align the support bars (Fig. 2 - 1) with the inner holes (Fig.
2 - 2) on the tool chest assembly.
2. Fasten the support bars to the tool chest assembly using a
M8x40 bolt, a washer, and a round-head nut. Repeat on all four
inner slots.
3. Tighten all four nuts with a 14mm wrench or socket (not
included).
ATTACH THE CASTERS
1. Gather both side trays (Fig. 3 - 1) and all four casters (Fig.
3 - 2).
2. Align the casters with the outermost holes on the side trays.
3. Fasten the casters with a washer, spring washer, and a
round-head nut (Fig. 3 - 3) using a 14mm wrench or socket
(not included). Repeat with all four casters.
WARNING!
Do not the item until it is fully assembled according to the instructions. Failure to follow the
safety instructions may result in serious personal injury.
1
1
2
2
1
2
2
Fig. 1
Fig. 2
Fig. 3
