ASSEMBLY & ADJUSTMENTS
INSTALLATION ON TABLES WITH THROUGH SLOTS
1. Slide the heads of the M8x90 bolts (Fig. 1 - 1) into the back
T-track (Fig. 1 - 2), one on each side, and slide one into the front
T-track (Fig. 1 - 3), if desired.
2. Position the bolts in the back T-track such that they fit through
the the slots on the metal drill press table. Place them through
the slots (Fig. 2). Position the table so that the front bolt is lined
up with the front of the table, or passes through a slot or hole in
the metal table, depending on your drill press model.
3. Attach the clamp assemblies to the bolts in the following or-
der: Clamp, clamp bushing, washer, knob (Fig. 3).
4. Tighten the knobs on the clamp assemblies. Make sure that
the drill press table is properly aligned and centered before the
knobs are fully tightened.
NOTE:
For the most secure clamping, have the clamps resting
against a flat surface underneath the table. If the front clamp
assembly is not placed through a slotted hole, have the rounded
end of the clamp (Fig. 4 - 1) gripping the front lip of the metal
drill press table (Fig. 4 - 2).
NOTE:
To ensure the clamps are locked into place properly, check
that the clamp bushings are properly seated into the clamps.
The rounded tops of the bushings (Fig. 5 - 1) should mate with
one of the rounded grooves in the clamps (Fig. 5 - 2). Once the
clamps are properly seated, fully tighten the knobs.
Fig. 1
Fig. 2
Knob
2
1
2
3
Washer
Bushing
Clamp
6
Fig. 4
1
Fig. 3
Fig. 5
2
2
1
Summary of Contents for DPA2513
Page 11: ...NOTES 11...
