![background image](http://html1.mh-extra.com/html/wen/56400m/56400m_instruction-manual_956378026.webp)
27
26
MAINTENANCE
INSPECTING/CLEANING THE SPARK ARRESTOR
Inspect and clean the spark arrestor every 100 hours of
operation
(refer to page 23, Table 4). The spark arrestor
is located outside the muffler, which gets very hot during
operation. Allow the engine to cool completely before ser-
vicing the spark arrestor.
1. Remove the two Phillips-head screws that secure the
spark arrestor to the muffler. See Fig. 18.
2. Remove the spark arrestor screen.
3. Carefully clean and remove the carbon deposits from the
spark arrestor screen with a wire brush. Replace the spark
arrestor if it is damaged. Replacement spark arrestors can
be purchased from
wenproducts.com
by searching the
part number
P54403
.
4. Reinstall the spark arrestor in the muffler and secure it in
place with the screws.
SPARK PLUG MAINTENANCE
Inspect and change the spark plug every 100 hours of
operation
(refer to page 23, Table 4). The spark plug
is important for proper engine operation. Check the spark
plug regularly to maintain proper engine operation. A good
spark plug should be intact, free of deposits, and properly
gapped.
1. Gently pull on the spark plug boot to remove it. Be care-
ful not to tear insulation or wire. See Fig. 19.
2. Use the included spark plug wrench (Fig. 20) to unscrew
the spark plug from the engine. Remove the spark plug
from the engine.
TIP:
There is limited space for the wrench
to turn. Use both rows of holes in the spark plug wrench to
gain leverage to loosen the plug.
3. Visually inspect the spark plug. If it is cracked or chipped,
or if the electrodes are worn or burned, discard it and re-
place with a new spark plug. We recommend replacing it
with an
NGK BP7ES/Torch F7TC
spark plug. These can be
purchased from
wenproducts.com
by searching part num-
ber
P54060
.
4. If re-using the spark plug, use a wire brush to clean any
dirt from around the spark plug base, then re-gap the spark
plug.
Instructions continue on the next page.
Fig. 18
Fig. 19
Fig. 20
Spark Plug Boot
Muffler
Spark Arrestor Assembly
Cylinder Assembly
Wrench (1)
Handle (1)