ASSEMBLY
All hardware comes pre-assembled with the nuts and
washers attached to the proper bolts for the wheels, legs,
and handles. See the packing list on page 9. For video
instructions, visit bit.ly/wheelkit.
INSTALLING THE WHEELS
Refer to the packing list on page 9 to gather the proper
parts and tools for installing the wheels.
1. Prepare a set of blocks on level ground (a 4×4 block of
wood works well). Place the generator on the blocks.
2. Remove both nuts and both washers from each axle as-
sembly (Fig. 1). Set aside.
3. Insert the short side of the axle into the opening on the
generator frame. Tighten the nut onto the axle using the
14/17mm wrenches. See Fig. 2.
4. Slide the large washer onto the body of the axle, then
slide on the wheel and the small washer. Tighten the nut
onto the axle using the 14/17mm wrenches. See Fig. 3. En-
sure the wheel can spin. If it cannot, loosen the nut slightly
until it spins. Repeat steps 3-4 with the second wheel.
INSTALLING THE LEGS
Refer to the packing list on page 9 to gather the proper
parts and tools for installing the legs.
NOTE:
The hardware
for the legs are the four smaller pre-assemblies. The hard-
ware for the handles is slightly larger.
1. Remove the nuts from the bolts. Slide the legs into place
on the generator frame and align the holes on the legs with
the holes on the frame (Fig. 4).
2. Slide the bolts through the legs and generator frame.
Tighten the nuts onto the bolts using the 10/12mm wrench-
es (Fig. 4).
ASSEMBLY & ADJUSTMENTS
WARNING!
Do not plug in or turn on the tool until
it is fully assembled according to the instructions. Read
through and become familiarized with the following
procedures of handling and adjusting your tool. Failure
to follow the safety instructions may result in serious
personal injury.
10
Fig. 4
Leg
Nut
Frame
Axle Assembly
(2)
Fig. 1
Nut
Small Washer
Large Washer
Fig. 2
Nut
Axle - Short Side
Fig. 3
Large Washer
Small Washer
Nut