![background image](http://html.mh-extra.com/html/wen/40421/40421_instruction-manual_956557007.webp)
WARNING:
To reduce the risk of electric shock, always unplug the charger before perform-
ing any cleaning or maintenance. Do not allow water to flow into the charger. Use a Ground Fault
Circuit Interrupter (GFCI) to reduce shock hazards.
7
13. Sawing wood under tension necessitates an increased amount of caution. Wood that is suddenly
released from tension can react in a completely uncontrolled manner. This can result in severe to
deadly injuries. Such work may only be performed by trained specialists.
14. To reduce the risk of electrocution, never use near any electrical power lines. Contact with or use
near power lines may cause serious injury or electric shock resulting in death.
15. Always use two hands when operating the pole saw. Hold the pole saw with both hands to avoid
loss of control.
16. This tool is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
17. Wait until the chain has come to a standstill completely before placing it down.
18. Any servicing should be performed by an authorized service representative. If you need assis-
tance,
contact WEN customer service at 1-800-232-1195.
REDUCING KICKBACK
Kickback can occur when the tip of the guide bar touches an object or when the wood closes in and
pinches the saw chain inside of the cut. Tip contact can kick the guide bar up and back towards the op-
erator. Pinching the saw chain along the top of the guide bar can push the bar rapidly towards the op-
erator. Either of these reactions may cause a loss in control of the pole saw, increasing the chances of
serious personal injury. Do not rely on the safety devices built into the saw. Pole saw users should take
as many precautions as possible to minimize on-site accidents. Kickback is the result of tool misuse
and/or incorrect operating procedures. These conditions can be minimized with the following steps:
1. Maintain a firm grip, with thumbs and fingers encircling the pole saw handle. Both hands should
be on the saw with your body and arms in a position to resist kickback forces. Kickback forces can be
controlled by the operator, if proper precautions are taken. Do not let go of the pole saw.
2. Do not overreach and do not cut above shoulder height. This helps prevent unintended tip contact
and enables better control of the pole saw in unexpected situations.
3. Only use replacement bars and chains specified by WEN. Incorrect replacement bars and chains may
cause chain breakage and/or kickback.
4. Follow the manufacturer’s sharpening and maintenance instructions for the pole saw. Decreasing the
depth gauge height can lead to increased kickback.
SPECIFIC SAFETY RULES FOR POLE SAWS