![background image](http://html.mh-extra.com/html/wen/40421/40421_instruction-manual_956557012.webp)
12
1. EXAMINE EXTENSION CORD BEFORE USE. Make sure your extension cord is properly wired and in
good condition. Always replace a damaged extension cord or have it repaired by a qualified person before
using it.
2. DO NOT ABUSE EXTENSION CORD. Do not pull on cord to disconnect from receptacle; always discon-
nect by pulling on plug. Disconnect the extension cord from the receptacle before disconnecting the prod-
uct from the extension cord. Protect your extension cords from sharp objects, excessive heat and damp/
wet areas.
3. USE A SEPARATE ELECTRICAL CIRCUIT FOR YOUR TOOL. This circuit must not be less than a
12-gauge wire and should be protected with a 15A time-delayed fuse. Before connecting the motor to the
power line, make sure the switch is in the OFF position and the electric current is rated the same as the
current stamped on the motor nameplate. Running at a lower voltage will damage the motor.
When using an extension cord, be sure to use one heavy enough to carry the current your product will
draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The
table below shows the correct size to be used according to cord length and ampere rating. When in doubt,
use a heavier cord. The smaller the gauge number, the heavier the cord.
AMPERAGE
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft.
50 ft.
100 ft.
150 ft.
2.5A
18 gauge
16 gauge
14 gauge
12 gauge
GUIDELINES AND RECOMMENDATIONS FOR EXTENSION CORDS
ELECTRICAL INFORMATION
1. POLARIZED PLUGS. To reduce the risk of electric shock, this equipment has a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do
not modify the machine plug or the extension cord in any way.
2. GROUND FAULT CIRCUIT INTERRUPTER PROTECTION (GFCI) should be provided on the circuit or outlet
used for this power tool to reduce the risk of electric shock.
3. SERVICE AND REPAIR. To avoid danger, electrical appliances must only be repaired by qualified service
technician using original replacement parts.