![background image](http://html.mh-extra.com/html/wen/3920/3920_manual_956543011.webp)
11
BENCH MOUNTING THE SAW (Fig. 7-8)
Before operating the saw, it must be firmly mounted to a workbench or another rigid frame. Use the base of the saw
to mark and pre-drill the mounting holes.If the saw is to be used in one location, permanently secure it to the work
surface using wood screws if mounting to wood. Use bolts, washers, and nuts if mounting into metal. To reduce
noise and vibration, install a soft foam pad (not supplied) between the scroll saw and the workbench.
Note:
mounting hardware not included.
WARNING - to reduce the risk of injury:
- When carrying the saw, hold it close to your body to avoid injury to your back. Bend your knees
when lifting the saw.
ASSEMBLY AND ADJUSTMENTS
FIGURE 8
- Carry the saw by the base. Do not carry the saw by the
power cord.
- Secure the saw in a position where people cannot stand, sit,
or walk behind it. Debris thrown from the saw could injure
people standing, sitting, or walking behind it.
- Secure the saw on a firm, level surface where the saw can-
not rock. Make sure there is adequate room for handling
and properly supporting the work piece.
Blade guard foot adjustment (Fig. 7 and 8)
When cutting at angles, the blade guard foot should be adjusted
so it is parallel to the table and rests flat above the work piece.
1. To adjust, loosen the screw (2), tilt the foot (1) so it is par-
allel to the table, and tighten the screw.
2. Loosen the height adjustment knob (3) to raise or lower
the foot until it just rests on top of the work piece. Tighten
the knob.
3
FIGURE 7
1
2
Summary of Contents for 3920
Page 8: ...8 KNOW YOUR SCROLL SAW ...
Page 20: ...20 EXPLODED VIEW PARTS LIST ...