Wen 23114, Manual

Page: 10 / 18

No. Accessory Explanation & Applications
1
Collet
(Ø1/8", Ø3/32",
Ø1/16")
For holding a rotary tool bit in place. Your tool comes with Ø1/8", Ø3/32",
Ø1/16" sized collets. Always use the correct collet size that matches the shank
diameter of the rotary tool bit.
2
Sanding Band
(Big & Small)
Slides over the top of the sanding drum mandrel to sand and smooth around
surfaces and inside curves. Replace the sanding bands when the grits are
worn down. Do not use at speeds higher than 15,000 RPM.
Attach to No. 15 Sanding Drum Mandrel.
3 Felt Polishing Wheel
Screws onto the top of the screw mandrel to clean, polish and buff metal,
wood and plastics to a smooth and bright finish. Do not use at speeds higher
than 15,000 RPM.
Attach to No. 7 Screw Mandrel.
4 Sanding Disc
Disc-shaped sandpaper used for material removal and resurfacing.
Attach to No. 8 Small Screw Mandrel.
5 Resin Cut-off Wheel
Thin disc used for slicing and cutting screws, sheet metal, thin wood and
plastics. Only cut along the wheel's edge; do not use for sanding or cutting
curves. Attach to No. 8 Small Screw Mandrel.
6 Dressing Stone
A solid block made of hard abrasive. Breathes new life back into old or worn
grinding wheel and grinding stone bits.
7
Screw Mandrel
(Ø1/8")
A mandrel with a screw head for attaching felt polishing accessories.
8
Small Screw Mandrel
(Ø1/8")
A mandrel with a threaded head, rubber rings and slotted tip for attaching
wheel accessories.
9 Wire Brush (Ø1/8")
For general cleaning and polishing purposes.
Do not use at speeds higher than 15,000 RPM. Can be used with polishing
compound for more efficient cleaning or polishing.
CAUTION: Excessive pressure can damage the wires. Operate with light
pressure and let the tips of the wire brush do the work.
10
Felt Polishing Bit
(Ø1/8”)
Use for polishing and buffing jewelry, soft metal, wood and plastics.
11
Diamond Coated Bit
(Ø1/8")
Bits of various shape to efficiently cut and engrave in wood, plastics, and soft
metals such as aluminum, copper, and brass.
12 Wrench
Use the front of the wrench for loosening the collet nut to change collets.
Use the back of the wrench for adjusting the screws on the sanding drum and
small screw mandrel, and for opening the carbon brush covers.
Refer to the chart below for explanations and recommended applications for your rotary tool accessory bits.
KNOW YOUR ACCESSORIES
10