Weltem WPH-5000, Owner'S Manual

Page: 11 / 24

ICEN MANUAL
11
TEMP SELECT
Button
·
Choose temperature sensor by pressing this butt on shortly.
·
When IN lamp is on, inlet temperature sensor works so it is used to control
inside of a room.
·
When OUT lamp is on, outlet temperature sensor works so it is used to
provide cool air or hot air directly to people or material.
·
By pressing this butt on for 2 seconds, SET lamp will be on and SET mode
acti vates. Then set the target temperature by pressing UP/DOWN BUTTONS.
Aft er setti ng the target temperature, press TEMP SELECT BUTTON for 2
seconds and SET lamp will be off and setti ng temperature will be memorized.
MODE
Button
·
Choose cooling, heati ng or auto by pressing this butt on. When all lamps are off ,
it is blower mode so only fan operates without operati ng compressor.
·
When AUTO lamp is on, it acti vates cooling or heati ng automati cally
according to TARGET TEMP. It acti vates cooling when TARGET TEMP is
lower than CURRENT TEMP and will change to acti vate
heati ng when CURRENT TEMP reach over the TARGET TEMP by 6°F( 3°C)
and change to acti vate
1) Control mode can changed sequentially whenever
button is pressed. ( IN → OUT → SET )
1) Control mode can changed sequentially whenever
button is pressed.( AUTO → COOL → HEAT → BLOWING )
· AUTO light on : COOL/HEAT is operated automatically when
is controlled on IN.
· COOL light on : COOL mode is operated.
· HEAT light on : HEAT mod is operated.
· ALL light OFF : Blowing.
2) Temperature which you want can be selected
- Between 0℃ and 50℃ can be selected.
3) It is saved when MODE button is pressed for 2 seconds.
(2) Descripti on of the display panel for I-CEN (All models)