WellGate 3512 Technical Manual EN-V1.00
Copyright © 2007 Welltech Computer Co., Ltd. All right reserved.
20
Wireless Basic Settings
This page is used to configure the parameters for wireless LAN clients, which may connect to your
Access Point.
¾
Band: Select wireless band as 802.11b, 802.11g, or 802.11b+g.
¾
Mode: Select wireless mode. User could find 4 different modes here, including AP, Client,
WDS, AP+WDS. AP mode enables WG3512 as wireless access point and allows other
devices to connect wirelessly to a wired Ethernet network. Client mode enables WG3512 to
perform as a wireless client card and other devices can connect with Ethernet cable to
WG3512. WDS mode is to extend the wireless coverage of another wireless AP. AP+WDS
enables WG3512 to perform as an AP and a WDS repeater. Here we will guide you how to
setup it with AP mode.
¾
Network Type: Only when wireless mode set as client, user can select network type as
infrastructure or Ad hoc. Infrastructure represents a wireless network centered about an
access point. Ad hoc represents a wireless network composed only of stations within mutual
communication range of each other.
¾
SSID: specify to the WG3512 an SSID (Service Set Identifier), which is a unique identifier
attached to packets over WLAN. The SSID is up to 32 ASCII characters that differentiate the
WG3512 from other WiFi AP, and it is also referred to as the ESSID (Extended Service Set
Identifier). You may use the default SSID unless there more than one WG3512 in the same
area. In this case, you should specify different SSID for each WG3512.
¾
Channel Number: Set channel for wireless connection. You can set channel for radio