ATA Web user guide
28 / 114
2015/1/8
(Figure 1)
Item Decription
Forward Type of
phone1
Default is Disable. To configure Phone 1 forward type.
Here provides 5 options: Disable, All (unconditional), Busy, No
Answer, Busy or No Answer.
NOTE
：
Please make sure your service provider support this
forward function.
Forward Number
of phone1
To configure Phone 1 forward number, simply dial [number or
digit string]. The maximum digit length is 63.
Rings of phone 1 That feature is used for no answer forward only. Default is 3
rings. When there is no answer after configured rings, ATA
forward to pre-configured number automatically. The
configuration ring range is 2 to 8 rings.
This mode only supports
Forward Type: No Answer.
Hotline Type of
phone 1
Phone 1 hotline function, default is disable. Enable: ATA will dial
the hotline number immediately when you pick up phone.
Note:
You need to configure Hotline number in advance. See the next
row.
Hotline Number
of phone 1
Configure Phone 1 hotline number. You can enter IP address or
number or digit string and the maximum length is 63 digits. For
instance, IP address: 192.168.1.23 or telephone number:
0800024365.
Delay of phone 1 When you pick up the phone before dialing, ATA start to count
time until the first digit was dialed. Default time is 3 seconds.
ATA will use Hotline number to dial if configured time was
expired. The configuration range is 1 to 6 seconds.
DND Type of
phone 1
Configure Phone 1 DND function, default is Disable. When you
set to
Enable
, ATA will response SIP command 486 message
(Busy status) to calling user once an call incoming. There are 3
options to configure:
Disable, Always, Period (DND enable
according pre-defined time period, refer to time setting at next
row)
.
DND Time of
This command is to configure DND time period at phone 1.