Weller Zero Smog TL, Translation Of The Original Instructions

Page: 18 / 121

16
GB
ENGLISH
sounds again the next time the unit is turned on, the
filter must be changed.
If no action is taken, the filter unit will cut out after five
minutes in order to avoid overheating.
When changing the main filter the filtration time can be
reset as follows:
Keep the UP/DOWN buttons pressed and, at the same
time, turn on the switch until an audible signal sounds.
Release the buttons, wait 5s and turn the unit off. Wait
another 5s and turn the unit on. Filtration time is now
reset.
Cleaning
To ensure that the unit functions properly, the nozzle,
extractor arm and connecting hose must be cleaned
on a regular basis.
Warranty
Claims by the buyer for physical defects are time-
barred after a period of one year from delivery to the
buyer. This does not apply to claims by the buyer for
indemnification in accordance with §§ 478, 479 BGB
(German Federal Law Gazette).
We shall only be liable for claims arising from a warranty
furnished by us if the quality or durability warranty has
been furnished by use in writing and using the term
„Warranty“.
The warranty shall be void if damage is due to improper
use and if the device has been tampered with by unau-
thorised persons.
Subject to technical alterations and amendments.
For more information please visit www.weller-tools.
com
Error messages and error clearance
Message/symptom Possible cause Remedial measures
„
Extraction power missing
„
Pipe system leaking
„
Reseal the pipe system
„
Filter is dirty
„
change the filter
„
Unit is not running
„
Thermally switched off
„
Leave the unit to cool down. Switch
on again after approx. 3 hours.
„
Device does not work
„
Fuse is blown
„
Please contact our Customer
Service: technical-service@
weller-tools.com
„
Unit is not properly connected
„
Check the electrical connections
„
Sub-micron paricle becoming dirty
to quickly
„
Pre-filter has not been used
„
Use a pre-filter Fit an F7 filter Use
a preliminary seperator if the
proportion of solid matter is high.
Technical Data
Solder fume extraction Zero Smog TL
Dimensions L x W x H mm
inch
335 x 330 x 445
13.19 x 12.9 x 17.52
Weight kg 9
Mains supply voltage (V/Hz) 230 / 50 (FT91013699)
120 / 60 (ZEROSMOGTL)
Power consumption (V/W) 230/110
120/110
Operating sound level from 1 m
distance
db(A) 53
Maximum vacuum (Pa/V) 3000
Maximum quantity supplied (m³/h) 190
Gas filter l 2,5
Pre filter
Filter F7 collects 40-60% fine dust > 1 mm.
Combined filter Combined H13 high efficiency submicron filter (99.95 % particle sepa-
ration upto 0.12 μm)
in combination with an activated carbon filter