28
16. Remove the power plug from the socket before opening the unit.
17. Remove all maintenance tools.
Before switching on the unit, check that all maintenance tools have been removed
from the unit.
18. Avoid unexpected operation.
Make sure that the mains switch is turned off when inserting the plug into the socket
or connecting to mains. Don't hold a soldering tool which is connected to a mains
supply while touching the mains switch.
19. Pay attention.
Be careful of what you do. Work with caution. Don't use the soldering tool if you are
not concentrated on your work.
20. Inspect the soldering tool for any damage.
Before further use of the soldering tool, safety devices or slightly damaged parts must
be carefully checked for error-free and intended operation. Inspect moving parts for
error-free operation and that they don't bind, or whether any parts are damaged. All
parts must be properly mounted and all requirements fulfilled for guaranteed error-
free operation of the soldering tool. Damaged safety devices and parts must be
repaired or replaced by a qualified technician, so long as nothing else is indicated in
the Operation Manual.
21. Attention.
Use only accessories or attachments which are listed in the accessories list of the
Operation Manual. Use only WELLER accessories or attachments on original WELLER
equipment. Use of other tools and other accessories can lead to a danger of injury.
22. Repairs to your soldering tool should be carried out by qualified technician.
This soldering tool is in accordance with the relevant safety regulations. Repairs
should only be carried out by a qualified electrician using original WELLER
replacement parts. Failure to do so can lead to accidents for the operator.
23. Do not work on electrically live parts.
The grip of antistatic designed soldering tools is conductive.
24. Do not connect any combustible gases.
No combustible gases may be connected to hot-air, respectively hot-gas devices. Do
not point the hot gas jet at persons, respectively do not look into the hot-gas jet.
Provide for sufficient ventilation in case of internal gases.
25. Applications with other WELLER equipment.
If the soldering tool is to be used together with other WELLER equipment and
attachments, also observe the warning notices given in the corresponding Operation
Manual.
26. Observe the valid safety regulations for your work place.
