Weller HAP 200, Operating Instructions Manual

Page: 16 / 128

6-6 HAP 200
5.1 Operating guidelines
Caution!
Excessively long nozzle threads can damage the
heater core of your tool.
The max. thread depth for hot air nozzles is 5 mm (0.2 "). Use of
longer threads will cause irreparable damage to the heater core.
Z
Pay attention to the correct thread depth of the screw-in
nozzles!
Z
Always use Weller original hot air nozzles!
The HAP 200 is supplied with an 8 mm socket wrench. Use this to
replace the nozzles. Lock the nuts on the heater core using the
supplied open-end wrench.
Note If you screw the enclosed nozzle adaptor (5) (005 87 610 28) into
the HAP 200 using the 8 mm socket wrench, you can use the same
nozzles as for the HAP 1.
Replacement Hot Air Tools are supplied preset and can be
connected up and used without any need for readjustment.
To check the hot air temperature, it is recommended that you use a
special test nozzle (005 87 278 08) which mates with a sheathed
thermocouple (Ø 0.5 mm).
6 Accessories
HAP 200 hot air nozzles (see overview Hot Air Nozzles)
7 Disposal
Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.
8 Warranty
Claims by the buyer for physical defects are time-barred after a
period of one year from delivery to the buyer. This does not apply to
claims by the buyer for indemnification in accordance with
§§ 478, 479 BGB (German Federal Law Gazette).
We shall only be liable arising from a warranty furnished by us if the
quality or durability warranty has been furnished by use in writing
and using the term "Warranty“.