pool
lining
clamping stripe
zip
pool
wall
cover
ca.5 cm
ca.25cm
��
---
--z_
��
���--, �-
12. FILLING THE POOL WITH WATER
applying to: round-shaped pools, figure-eight-shaped pools,
oval-shaped pools
Take care that the welding seam of the lining between bottom
and wall is placed exactly in the corner bottom/wall of the pool.
Remove the last wrinkles before filling the pool.
Again, make sure that the liner lies tightly at the walls and that
there are virtually no wrinkles left. The last remaining wrinkles can
be 'ironed' easiest by filling the pool with 2 cm of water. Now the
wrinkles can be corrected. The correction is done best by getting
into the pool, with no shoes on, in order to smooth the foil with
your feet. Now you can continue filling your pool up to 10 cm be
neath the first fittings. Please, only use taped water and not water
from a well. Water from wells often contains metal particles (iron,
manganese) and may in combination with the pool-care products
cause oxidation and discolouring of the pool water.
13. ASSEMBLING THE HANDRAIL
applying to: round-shaped pools, figure-eight-shaped pools,
oval-shaped pools
For an oval-shaped pool start at the straight side (wall).
Fittings/SafeTop
®
- assembly: If you purchased our SafeTop
®
cover, please observe the according assembly instructions.
Connect two handrail sections with a connecting tube and press
the handrail over the hanging profile with the groove onto the
pool wall. However, before you press down the handrail comple
tely, insert the next handrail section thus gradually completing the
whole handrail.
If necessary, spaces between the sections have to be closed
tightly by removing the handrail once more. Where the first and
the last handrail segment meet, the last handrail segment might
be too long.
If so, cut the section to the right length on one side with a metal
saw. In order to close the last handrail segments, please take off
the ends of both segments from the side wall. Now insert the
connecting tubes into the last piece and press the complete
handrail back onto the pool wall.
Changes in temperature may cause spaces between the single
handrail segments which is quite normal. You might want to insert
a sawn off piece. Attention: Do not stand or sit on the pool wall
(handrail)!
14. ASSEMBLING THE COVER PLATFORM
applying to: figure-eight-shaped pools
Now fix both cover platforms, each with 4 screws, on top of the
vertical rails. The platform should provide a clean top finish of the
base support and should cover sharp edges. Do not use as
springboard.
