14
Access to the LEARN-button
2.7. Receiver
The receiver is built-in in your appliance and has a 3-position slide button:
LEFT:
OFF
(the system is OFF)
MIDDLE
:
REMOTE
(the system only operates if the receiver receives commands from the transmitter)
RIGHT
:
ON
(the system remains ON in low flame until the slide switch is placed in the OFF or REMOTE position)
We advise you to put the slide switch in the
OFF
position if you will be away from your home for an extended period of time
or during summer. Placing the slide switch in the
OFF
position also functions as a safety ”
LOCK-OUT
” by both turning the
system off and rendering the
TRANSMITTER
inoperative.
2.7.1. Matching security codes (LEARN)
Each transmitter can use one of the 1.048.576 security codes. It may be
necessary to program the remote receiver to
LEARN
the security code of the
transmitter, upon initial use, if batteries are replaced or if a replacement
transmitter is purchased. When matching security codes, be sure the slide
button on the
RECEIVER
is in the
REMOTE
position: the code will not
LEARN
if the slide switch is in the
ON
or
OFF
position. Program the remote
RECEIVER
to
LEARN
a new security code by pushing in the
LEARN
-button on the top of
the remote
RECEIVER
until a beep is heard and then pressing
MODE
on the
TRANSMITTER
. The
RECEIVER
will emit a series of rapid beeps indicating the
transmitter‘s code has been programmed into the receiver. When an existing
receiver is matched to a new transmitter, the new security code will overwrite
the old one
REMARK: The microprocessor that controls the security code matching procedure is controlled by a timer
function. If you are unsuccessful in matching the security code on the first attempt, wait 1-2 minutes before trying
again: this delay allows the microprocessor to reset its timer circuitry.
