13
2.6
Receiver
The receiver
is built-in in your appliance and has a 3-position slide button:
LEFT
:
REMOTE
(the system only operates if the receiver
receives commands from the transmitter)
MIDDLE
:
ON
(the system works manually)
RIGHT:
OFF
(the system is OFF)
We advise you to put the slide switch in the OFF position if you will be away from your home for an extended
period of time or during summer.
This will enhance the lifespan of the controls!
There’s 4 additional buttons:
LEARN
: (see 2.6.2)
FLAME- & FLAME+:
manual control of the flame height (see 2.6.1.)
RESET
: (see 2.5.1 and 2.6.1)
2.6.1.
Manual control
In case the transmitter shouldn’t function, you can control your heater manually. Place the slide button on the
receiver in the ON-position, and next push the
FLAME-DOWN
and
FLAME-UP
buttons simultaneously during 3
seconds to ignite the heater. With these same buttons you can control the flame height manually (
FLAME UP
= big
flame,
FLAME DOWN
=small flame).
To switch of the heater again, push the
RESET
button
2.6.2.
Matching security codes (LEARN)
Each transmitter can use one of the 1.048.576 security codes. .
When matching security codes, be sure the slide button on the
RECEIVER
is in the
REMOTE
position and also make
sure the transmitter is switched
OFF.
. The code will not
LEARN
if the slide switch is in the
ON
or
OFF
position..
Program the remote
RECEIVER
to
LEARN
a new security code by pushing in the
LEARN
-button on the
RECEIVER
for
3 seconds, until you hear a beep. Then, within 10 seconds, press
UP
and
DOWN
simultaneously
on the
TRANSMITTER
. The
TRANSMITTER
will automatically be switched
ON
, and the
RECEIVER
will emit a series of 4 rapid
beeps indicating the transmitter‘s code has been programmed into the receiver.
