WF-205
MST
© Weldclass 2019 | E.&O.E. | Edition 2.1
23
7.1
MIG Welding
WARNING!
Before changing the feed roller or wire spool, ensure that the mains
power is switched off.
7.1.1
Fitting Wire Spool – 100mm Diameter (1kg)
1.
Open the wire feeder compartment door.
2.
Remove the Spool Nut (9) by threading it anticlockwise
3.
Remove the Spool Tension Nut, Spring and Washer
4.
Remove the Spool Post (8)
5.
Fit the wire spool to the Spool Post Bolt, ensuring that the wire exits the spool towards the wire
feeder from bottom of the spool.
6.
Replace the Washer and Spool Tension Nut.
NOTE: The Spool Nut, Spring & Spool Post are not required for 100mm spools.
7.
Feed the wire from the spool through the Wire Inlet Guide (15) into the wire feeder.
8.
Set the Spool Brake Tension by adjusting the Spool Tension Nut. The spool brake tension should
be set so that the spool can rotate freely, but does not continue to rotate/unravel wire once the
wire feed stops.
Figure 17
Washer
Spool Tension Nut
Spool Post Bolt
Spool nut (not required for 100mm spools)
Spring (not required for 100mm spools)
Spool Post (not required for 100mm spools)
Wire Inlet Guide
Summary of Contents for WeldForce WF-205MST
