9
SCANTEAM 6980 User’s Guide
In Programming mode, the following parameters are
programmable:
•
communication parameters
•
beeper enable/disable
•
MSR track decode selection
Note:
To set options in the “Programming” mode all commands MUST BE
typed in with an AT type keyboard.
Enabling or Disabling Track Configurations and / or Beeper
1.
Turn off power to the SCANTEAM 6980. (If a PC provides
power to the MSR, then turn the PC off.)
2.
Set MSR DIP switch position 8 to OFF.
3.
Turn on power to the MSR.
4.
Run the software utility by typing the executable file name
at the command line. The executable file is that shown on
the SCANTEAM 6980 Programming Utility disk received
with the MSR.
Example:
A:\MENU100A.EXE
The disk is in drive A and the executable file name shown on
the disk is MENU100A.EXE."
5.
Follow the setup instructions on the disk:
•
Select the COM port, baud rate, number of data bits and
parity. Communication parameters selected must match
those set by the switch selections of the MSR being
programmed.
•
Select the track enable/disable configuration you need.
•
Enable or disable the beeper.
6.
Turn off power to the MSR.
7.
Set MSR DIP switch position 8 to ON.
8.
Reapply power to the MSR.
Note:
Triple track enable/disable options are not available with a two track
MSR.
Summary of Contents for SCANTEAM 6980
