8 / 13
© 2016 Spectrum Brands, Inc.
Kevo Support: www.weiserlock.com/kevo/support
USA: 1-800-677-5625 • Canada : 1-800-501-9471
7
Perform the door handing process.
A
B
C
D
status
LED
Install 4 AA batteries in the battery pack.
IMPORTANT:
Make sure the door is open. Insert the battery pack
while
PRESSING AND HOLDING
the Program button. Release the
button when the battery pack is all the way inside the lock interior.
IMPORTANT:
The Status LED will flash red and green, and the
lock will beep. Press and release the Program button again.
The latch bolt will retract and extend on its own to learn the orientation of the door.
Red Status LED
OTHER DEADBOLTS:
If the Status LED is solid red after
door handing, make sure the
batteries are installed correctly
and the lock interior is correctly
installed. Perform steps B-D again.
The Status LED will turn green or red.
Green:
Door handing successful.
Continue to step 8.
Red:
See “Red Status LED” below.
If the bolt does not move, make sure the batteries are
installed correctly, and perform steps B-D again.
This step will teach the lock the orientation of your door and is crucial for lock operation.
Ensure correct polarity. For best
results, use new, non-rechargeable
Alkaline batteries only.
Right
BALDWIN ESTATE DEADBOLTS ONLY:
If your latch bolt is to the RIGHT of your
interior assembly, and the Status LED is
solid red after door handing,
press and
release the Program button again
. The
door handing process will restart.
If you are unsure if your lock is
Baldwin Estate, see chart on page 3 or
compatible deadbolt list on page 11.
