The Weir Group PLC
Weir Industrial Gateway setup guide rev 0.5
Copyright © Weir Minerals Australia Ltd 2017. Commercial in Confidence. All rights reserved.
Page
28
of
46
Tools required to remove and replace slurry guards
o
Torx T27 driver
12.5.4.211.5.4.2
Hazards
No direct hazards of note
12.5.4.311.5.4.3
Installation
1. Run the cable between the MPM and RSP
2.
RSP :
Remove connector shroud
Images needed showing screw locations
3.
RSP :
Remove the connector cap from J5
Figure 11-9 MPM Comms + power connector on RSP
4.
RSP :
Pass the MPM -> RSP comms + power cable through the hole in the shroud
associated with J5 and make the connection by pushing and turning the bayonet
fitting.
5.
RSP :
Ensure that all other connectors not being utilised have their protective caps
installed
6.
RSP :
Re-install the connector shroud per Fig 7.2
7.
MPM:
Remove the connector shroud, ensuring that the retaining screws are secured
ie do not lose these (no spares are shipped)
8.
MPM:
Feed the MPM<->RSP cable through the shroud hole associated with the port
being used for this RSP ie one of the four shown below
Figure 11-10 RSP comms + power connectors on MPM
