© 2021 WEINZIERL ENGINEERING GmbH
Seite 4/20
2.1 KNX programming mode
The KNX programming mode is activated/deactivated by pressing the KNX programming button
❻
. When programming mode is active, the programming LED
❼
lights up red.
2.2 Manual operation and status display
Summary of the states of the programming LED
❼
:
Pressing the button Test
❺
briefly switches between normal operating mode and test mode. The
active mode is indicated by the LED Run
❷
lighting up or flashing slowly in green.
Summary of the states of the LED Run
❷
:
2.2.1 Normal operating mode
The LED WiFi
❸
lights up green when a Wi-Fi connection is available. If this LED flickers,
telegram traffic is taking place via Wi-Fi. If this LED flashes slowly in green, the device is not
connected via Wi-Fi.
Pressing and holding the button Test
❺
executes WPS (Wi-Fi Protected Setup). This is indicated
by the LED WiFi
❸
flashing fast in green.
Summary of the states of the LED WiFi
❸
:
LED Status
Meaning
LED lights red
The programming mode is active.
LED flashes red (fast)
The programming mode is not active.
The device is not loaded correctly, e.g. after aborting a download.
LED Status
Meaning
LED lights green
The device operates in normal operating mode.
LED flashes green (slowly)
The device is in test mode.
LED flashes green (fast)
The device is currently loaded by the ETS.
LED Status
Meaning
LED lights green
The device is connected via Wi-Fi.
LED flashes green (slowly)
The device is not connected via Wi-Fi.
LED flashes green (fast)
WPS is in progress.
LED flickers green
Telegram traffic via Wi-Fi.
