41
GB
Installation and Operating Instructions
Remote control heater adjustment
The Combio-868 HD can be used to turn the Tempura heating
system on and off and to set the level.
Intended use
The Combio-868 HD may only be used for controlling Tempura
heating system.
The Combio-868 HD 1.5 kW is suitable for a Tempura with a nomi-
nal output of 1500 watts. The Combio-868 HD 3.0 kW is suitable
for a Tempura with a nominal output of 3000 watts.
Note:
Do not shorten or lengthen aerial.
1. Install the Tempura or Tempura Duo as described in the
assembly instructions accompanying the heating system.
2. Disconnect from the mains.
3. Connect the Combio-868 HD 1.5 kW/3.0 kW to the heating
system. A STAS 3 Hirschmann plug is connected to the heating
system, which can be connected directly to the output of the
receiver unit. Do not remove this plug and especially not the
silicon cable attached to the Tempura!
The Hirschmann plug on the Tempura is wired as follows:
WeiTronic Combio-868 HD 1.5/3.0 kW
Summary of Contents for WeiTronic Combio-868 HD 1.5 kW
Page 56: ......
