BiConnect BiRec Ma + MA-K
Version 2
2016-04-20
Assembly and installation instructions/ Instructions de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques Numéro d’article 117476-0000 Page 9/28
5
Troubleshooting
Type of fault
Cause
Remedy
Awning does not react to the
signal sent by the hand
transmitter
•
No power supply
•
Reconnect power supply
•
Awning has not been
programmed
•
Program the awning
•
Empty batteries in hand
transmitter
•
Replace batteries
Drive moves in wrong direction
•
Directions have been
programmed incorrectly
•
Delete channel and
program correctly
Following a DOWN command,
awning extends only a short
way, then immediately retracts
•
Receiver is in lock mode:
maximum wind factor on
sun/wind or sun/wind/rain
sensor exceeded
•
Lock mode is removed
automatically 15-20 minutes
after the maximum wind
factor was last exceeded
•
BiSens Agido-3V product
protection sensor has
been triggered in last few
minutes
•
The device unlocks
automatically after 15-20
minutes
•
Programmed sun/wind or
sun/wind/rain sensor is
faulty or incorrectly
installed
•
The device will only unlock
when the fault has been
remedied
Awning moves UP and cannot
be halted or extended
•
"Wind alarm":
Programmed sun/wind
and/or sun/wind/rain
sensor or BiSens
Agido-3V product
protection sensor has
been triggered
•
The device unlocks
automatically after the
designated period
Following an UP command,
the awning stops after a while
then continues
•
BiSens Agido-3V battery
empty
•
Replace batteries in a
programmed BiSens
Agido-3V product protection
sensor
The awning can not be
programmed
a) using a BiEasy
handtransmitter
b) using a Remoto hand
transmitter
a) Program settings for
the unidirectional
transmitter/ sensor
e.g. Remoto still
active
b) Program settings for
the bidirectional
transmitter/ sensor
e.g. BiEasy still
active
•
Delete old transmitter
completely then program
the awning using the new
transmitter
Table 3: Troubleshooting
