Operating Manual Sesam 800 from Åkerströms
Operation
Activating the Transmitter
The transmitter is delivered with the batteries not installed. Insert the batteries according to chapter
”Replacing Batteries”.
Activate the transmitter by pushing the start button ”ON” for 3 seconds. The transmitter indicator will
flash GREEN quickly during startup and then flashing GREEN slowly when contact with the receiver is
enabled. The transmitter is now enable to control the winch.
Deactivating the Transmitter
To prevent unintended activation the transmitter shall be turned off when not used.
Turn off the transmitter by pushing button ”OFF” for three seconds, the indicator flashes a couple of
quick RED to finish with a long RED. The transmitter is now turned off. If you forget to turn off the trans-
mitter it will shut itself off after a time, idle-time (non-use).
Controlling the Device
The winch is controlled via the buttons on the transmitter.
The relationship between buttons and outputs are:
Button 1
Winch 1 ”IN”
Button 2
”ON” function (3 sec.)
*
Button 3
Winch 1 ”OUT”
Learning of Transmitter
If any part of the system has been replaced, the receiver and transmitter will need to be paired
together.
Dismount the cover of the receiver by remove the plastic caps to reach the screws.
Press the button ”ON” on the transmitter until the green indicator lights. The transmitter is now
active.
Press the Learn/Erase button on the receiver until LED 7 is ON.
The Learn Mode will be active for 10 seconds (as long as LED 7 is ON).
Press transmitter button 1 ”IN” to pair the transmitter to the receiver.
LED 7 blinks three times if the learning has succeeded.
Install the receiver cover and tighten the six screws to 2.0 Nm
Mount the caps over the screws.