上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
1
/
61
1 System Introduction
1.1 Overview
This section gives you a brief introduction of the hardware and software of the
NcStudio
Phoenix
Three-axis Engraving System
.
Hardware
Industrial computer: NC60A, NC65C, NC68A, etc.
Lambda controller
o
Lambda 21B: Applicable to bus control systems
o
Lambda 21A: Applicable to non-bus control systems
o
Lambda 20A and so on
EX series terminal board: EX31A
For the hardware connection diagram, see section 1.2 Hardware Connection Diagram.
Software
For introduction of the
NcStudio Phoenix Three-axis Engraving System
software
interface, see section 1.3 Software Interface.
1.2 Hardware Connection Diagram
Hardware connection method varies based on the control system type. Example of a non-
bus control system and a bus control system using NC60A are shown below.
Non-bus control system
Bus control system
