5
ASSEMBLY
1
2
3
4
5
5
6
7
12
9
10
10
11
11
7
7
7
7
7
7
2
4
4
6
6
6
7
7
7
9
4
8
8
1. Orient the Base (1) as shown. Attach a Base
Cap (4) to the Base with two M4 x 20mm
Screws (7). Attach the other three Base
Caps (4) in the same way.
2. Tighten the two Leveling Feet (5) into the
underside of the Base (1).
3. Orient an Upright (2) as shown. Attach
the Upright to the Base (1) with two M10 x
65mm Screws (6). Attach the other Upright
(2) in the same way.
4. Orient the Tray Frame (3) as shown. Attach
the Tray Frame to the Uprights (2) with four
M10 x 65mm Screws (6).
5. Orient a Tray (9) as shown. Tip: Start all the
Screws before tightening any of them.
Attach the Tray to the Tray Frame (3) with
eight M4 x 20mm Screws (7). Attach the
other Tray (9) in the same way.
6. Set six Weight Plates (10, 11, 12) in a Tray
(9) as shown. Then, press a Handle (8) onto
the Weight Plates. Repeat this step for the
other Weight Plates and Handle.
7. Make sure that all parts are properly
tightened before you use the dumbbells
and stand. Note: After assembly is com-
pleted, some extra parts may be left over.
Place a mat beneath the stand to protect the
floor.
Assembly requires two persons. Place all parts of the dumbbells and stand in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
.
Note: If a part is not in the hardware kit, check to see if it has been preassembled. To avoid damaging
parts, do not use power tools for assembly.
