12
20. Wrap the Short Cable (9) around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the 3 1/2Ó Pulley (35) to
the front bracket (M) underneath the Top Frame (1)
with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut
(63). Make sure the Bolt (62) is inserted from the
direction shown on the drawing.
Wrap the Short Cable (9) around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the 3 1/2Ó Pulley (35) to
the rear bracket (N) underneath the Top Frame (1)
with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut
(63). Make sure the Bolt (62) is inserted from the
direction shown on the drawing.
20
62
63
N
M
1
9
63
62
35
21.
Make sure the Short Cable (9) is in the groove of
all Pulleys and that the Cable and the Pulleys
move smoothly.
Attach the closed loop on the end of the Short Cable
(9) to the Weight Tube (25) with the 5/16Ó x 1 3/4Ó
Bolt (58) and a 5/16Ó Nylon Locknut (53). It will be
necessary to lift the Weight Tube and the Top Weight
to insert the Bolt through the Weight Tube and the
loop on the Cable.
21
58
9
22. Locate the Long cable (2). It is approximately 215Ó
long. Wrap the end with the ball around a 3 1/2Ó
Pulley (35) in the direction shown. Attach the Pulley
to the bracket (O) on the Base (8) with a 3/8Ó x 2Ó
Bolt (62) and a 3/8Ó Nylon Locknut (63).
Thread the Long Cable (2) through the Press Frame
(12). Wrap the Long Cable around a 3 1/2Ó Pulley
(35) in the direction shown. Attach the Pulley to the
Front Upright (42) with a 3/8Ó x 3 1/2Ó Bolt (54), a
Cable Trap (66), a 3/8Ó Flat Washer (55) and a 3/8Ó
Nylon Jamnut (57).
22
42
54
66
62
63
2
8
12
O
35
35
57
55
23. Remove the free Pulley (35) attached to the Pulley
Plates (31). Wrap the Long Cable (2) around the
Pulley in the direction shown.
Re-attach the Pulley (35) to the Pulley Plates (31)
with the 3/8Ó x 1 1/2Ó Bolt (60) and the 3/8Ó Nylon
Jamnut (57).
23
35
31
60
57
2
53
25
