8
10. Lubricate the 3/8Ó x 3Ó Bolt (88). Attach the Leg Press
Lever (83) to the Press Base (6) with the Bolt and a
3/8Ó Nylon Locknut (50).
Do not overtighten the
Nylon Locknut; the Leg Press Lever must pivot
easily.
10
11. Place two Weight Bumpers (51) over the indicated
holes in the Weight Base (5). Slide a Weight Guide
(15) into each of the holes.
Attach the indicated Weight Guide (15) to the Weight
Base (5) with a 3/8Ó x 2 3/4Ó Bolt (46), two 3/8Ó Flat
Washers (48), and a 3/8Ó Nylon Locknut (50).
Slide six Weights (21) onto the Weight Guides (15).
Make sure the Weights are turned so the pin
grooves point towards the floor.
Press a Weight Tube Bumper (18) into the lower end
of the Short Weight Tube (17). Slide the Weight Tube
into the center holes in the Weights (21).
Slide a Top Weight (16) onto the Weight Guides (15).
Note: Make sure the Top Weight is turned so the
groove fits over the welded pin on the Weight
Tube (17).
11
51
18
17
16
15
88
Lubricate
50
Groove
Pin
Pin
Grooves
6
83
21
48
50
9.
Press a 2Ó Square Inner Cap (28) into the Press Seat
Frame (7).
Slide the bracket on the Press Seat Frame (7) onto
the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (92) in the
Press Base (6). Hand tighten two 5/16Ó Nylon
Locknuts (64) onto the Bolts.
Do not tighten the
Nylon Locknuts yet.
Attach the Press Seat Frame (7) to the Press Upright
(2) with two 5/16Ó x 2 3/4Ó Bolts (89), two 5/16Ó
Washers (36), and two 5/16Ó Nylon Locknuts (64).
Do
not tighten the Nylon Locknuts yet.
9
89
36
7
28
89
6
2
92
64
64
64
46
5
48
36
