12
23. Attach the Butterfly Cable (73) to the bracket on the
Right Butterfly Arm (11) with a 3/8Ó x 1Ó Bolt (84) and
two 3/8Ó Nylon Jamnuts (63).
Note: The loop on the
Cable and the two Nylon Jamnuts must be mount-
ed underneath the welded bracket.
23
84
11
63
73
Bracket
24. Identify the Ab Cable (74). It is approximately 224Ó
long, and it has a ball on one end and a threaded
shaft on the other. You will start by attaching the end
of the Cable with the ball.
Wrap the Ab Cable (74) around a 3 1/2Ó Pulley (24) in
the direction shown. Place two Pulley Covers (47)
over the Pulley, so that the slots in the Pulley Covers
are placed over the Cable. Attach the Pulley and
Pulley Covers to the indicated hole in the Butterfly
Upright (1) with a 3/8Ó x 3 3/4Ó Bolt (59), two 3/8Ó Flat
Washers (48), and a 3/8Ó Nylon Jamnut (63).
Make
sure the Cable is between the Pulley and the
welded pin on the Upright.
24
1
74
24
48
63
48
59
47
22. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley
(27) in the direction shown. Attach the ÒVÓ-Pulley and
a Large Cable Trap (32) to the bracket
on the back
of the Butterfly Upright (1)
with a 3/8Ó x 2 1/2Ó Bolt
(53) and a 3/8Ó Nylon Locknut (50).
Make sure the
Large Cable Trap is oriented as shown.
22
53
27
73
Bracket
50
1
21. Remove both 3 1/2Ó Pulleys (24) from the pre-assem-
bled Small Pulley Bracket (22).
Wrap the Butterfly Cable (73) around a 3 1/2Ó Pulley
(24) in the direction shown. Attach the Pulley to the
Small Pulley Bracket (22) with a 3/8Ó x 1 3/4Ó Bolt
(57) and a 3/8Ó Nylon Locknut (50).
Make sure the
Small Pulley Bracket is oriented exactly as
shown.
21
73
50
24
57
22
Pin
32
