15
29. Wrap the Long Cable (73) around a “V” Pulley (21) in
the direction shown. Attach the “V” Pulley and a Long
Cable Trap (14) to the small tube on the Press Seat
Frame (52) with a 3/8” x 3 1/4” Bolt (28), a 3/8” Flat
Washer (17), and a 3/8” Nylon Locknut (4). Note: The
small tube has three adjustment holes. Mount the
“V” Pulley in the hole farthest from the Press
Frame Upright (59). Make sure that the Cable Trap
is oriented as shown.
30. Wrap the Long Cable (73) around a 3 1/2” Pulley (5)
in the direction shown. Attach the Pulley and a Cable
Trap (39) to the indicated hole in the Press Frame
(53) with a 3/8” x 3 1/4” Bolt (28), a 3/8” Flat Washer
(17), and a 3/8” Nylon Locknut (4). Make sure that
the Pulley is mounted on the inside of the Press
Frame and that the Cable Trap is oriented as
shown.
31. Route the Long Cable (73) around a 3 1/2” Pulley (5)
and back through the opening in the Press Frame
(53).
Remove the 3/8” Nylon Locknut (4) from the 3/8” x
4 3/4” Bolt (23) that was inserted in step 27. Attach
the Pulley and a Cable Trap (39) to the Bolt and
secure them with the Nylon Locknut. Make sure that
the Cable Trap is oriented as shown.
32. Note: Lift the Top Weight (78) on the weight stack
in order to create slack in the Long Cable (73)
before beginning this step.
Attach the Long Cable (73) to the Leg Lever (49) by
slipping the looped end of the Cable onto the looped
end of the 3/8” x 2 1/2” Eyebolt (83).
14
17
4
28
21
59
52
73
30
28
53
73
4
5
39
17
29
73
53
5
4
23
39
49
31
32
73
83
